Barebones 0.5W to 5W Drive Kit This circuit is designed to

This circuit is designed to switch a power amplifier (up to 100W) into the TX path during TX

The receiver in the RS-HFIQ consists of 5 band-pass filters to reject out-of-band signals

Elecraft or ELAD dongles and need 5V on pin 1 for power

The gain is about 20 dB with the output stage alone and about 40 dB with the MMIC

Barebones 0.5W to 5W Drive Kit This circuit is designed toNew REV C Version Increases the use of SMT components, reducing build time and complexity no transformer to wind. Uses the ATU mounting holes so no drilling is required. 0. 5 watts to 5 wattsDriverkit, which can be used as a final amplifier for a QRP project or to upgrade an existing HARDROCK 50 that was purchased without thedriver. SMT parts come pre soldered, and the following through hole parts are supplied: 1 x RD16HHF1 1 x 6" RG 316 2 x 2 pin