Carbide Pin - 40° Tip angle, Extra Length MB2015 Carbide stylus pin with a

Carbide stylus pin with a 120° tip angle

MB3315 Marking Unit

Comes standard with a normal tool post

The cable is also upgraded with additional wires for communication between the chuck and rotary unit

Carbide Pin - 40° Tip angle, Extra Length MB2015 Carbide stylus pin with aCarbide stylus pin with a 40 tip angle Standard Length: 72mm (standard is 52mm) Carbide hardness: HRA92 Recommended for Plastics This is sharpest tip angle and is recommended for plastics only. The extra length allows easier marking past the foot guard. It is especially important to ensure the pin is not placed in flexion during marking, as carbide is highly brittle and the likelihood of snapping is further increased over the standard length. For