JT Lite Eave Beam 14' 4" JUMBOTRAC

JT Lite Eave Beam 14' 4" JUMBOTRACThis kedered aluminum tubing is used as an eave perimeter in the Jumbotrac Lite frame tent system. This extrusion is used on all Jumbotrac Lite 15' middles and also on the ends of 15' wide and 30' wide Jumbotrac Lite gable and hip frame styles. Each length of tubing is drilled with parallel 5 16" diameter through holes located 3" from each end of the extrusion. Specifications: Base Material: 2. 57" x 2. 00" JT Eave Extrusion 6061 T6 Structural

This is the corner fitting for the traditional hip ended frame tent design

Tool-Free Tent Accessory Mounting - Installs in seconds—just slide and lock into any compatible keder track

The fitting has the keder cap attached for connections at the keder seams on all 10' wide to 20' wide hip ends and all extension middles for 10' wide through 30' wide Jumbotrac Lite frame tents

This kedered aluminum tubing is used as a rafter in the Jumbotrac 30' wide frame tent system on the hip end only

ultraviolet light from the sun will slowly breakdown these fibers over time

This is the corner fitting for the Festival CAN-T frame tent design

This part serves as the top end pin for our 2"OD Festival and Festival Can -T masts

One is used per jack and bolted to the the Canopy Jack Winch Bracket (#Z51400070)

Base Material: 5

This base plate is designed for the Jumbotrac Lite frame system and is designed to connect to the Jumbotrac Lite leg pipe

and (1) 1500lb Worm Gear webbing winch

this female drop-in anchor is used to securely attach your tent to a finished concrete slab