SCULPFUN S9 S10 30L/Min Air Assist Pump 12V Version With 32bit Mainboard Easy Installation Kit the laser will start the

the laser will start the tilt protection and shut down the Laserpecker laser

1×Y axis right profile

Take LaserPecker 2 with you and engrave flexibly with the exclusive power bank at any time

so it's lower power but high cost-effective

SCULPFUN S9 S10 30L/Min Air Assist Pump 12V Version With 32bit Mainboard Easy Installation Kit the laser will start theFeatures: 32 bit automatic air assist motherboard: it has an Sculpfun air assist interface and is compatible with LightBurn, and the automatic air pump is controlled on and off by the M8 air assist switch of the LightBurn software. It can effectively solve the problem of air assisted yellowing wood boards. Cutting air assisted opening, engraving air assisted closing can be realized. Integrated 30min min automatic air pump: The air pump is a DC 12V air