Musical Fidelity X-Tube Valve Buffer blue aura

Musical Fidelity X-Tube Valve Buffer blue auraThe purpose of a 'buffer' is to act as an interface between two items at line level (or between a pre amplifier and a power amplifier), helping remove any limitations from imperfect impedance matching that might exist. So for this reason the Musical Fidelity X Tube Buffer has a very high input impedance and low output impedance. This means it presents a very easy load to the item in front of it, whilst offering a very low output impedance to the item

It has had light use and is in overall very good condition with just the usual points showing wear - the headshell where the bolts are fitted and the side of the armtube where it goes into the arm clip

They are ultra wide bandwidth

whilst also being compatible with any normal half inch mount headshell

-Frequency response:    10 - 20 000 Hz +/- 2dB

Low Sensitivity    5

-Frequency Response    20 - 23

a pair of nuts

Effective Tonearm Length: 254mm

the latter having higher gain and presenting a lower impedance to the cartridge

If you have a damaged or worn out ND9 MM cartridge then don't fear

nickel plating) inertia moment 6

A temperature-controlled ultra-low-jitter crystal oscillator (TCXO) provides the master clock for the entire servo/decoder section