Carbide Pin - 60° Tip angle, Standard Length STD Standard Length: 72mm (standard is

Standard Length: 72mm (standard is 52mm)

Comes standard with a tool post stand

Key Benefits:

Patmark matches the MB3315 for window marking area

Carbide Pin - 60° Tip angle, Standard Length STD Standard Length: 72mm (standard isCarbide stylus pin with a 60 tip angle Standard Length: 72mm (standard is 52mm) Carbide hardness: HRA92 Can mark metal surfaces up to 62HRC, Suitable for most Plastics This pin angle is suitable for plastics. The deformation point of plastics is much higher than metal so a sharper tip angle allows for this to be overcome much more easily without having to increase the force, which can cause an overly wide mark. You can regrind the tip or we can offer