8" x 1/16" x 5/8" M2 For Thin Gauge Aluminum # of Teeth:350 This saw blade was made

This saw blade was made for production cutting and will not let you down

-5° hook angle with a 1" bore

6mm kerf and a 50mm arbor hole

Triple Chip Grind (TCG)

8" x 1/16" x 5/8" M2 For Thin Gauge Aluminum # of Teeth:350 This saw blade was madeThis blade is made explicitly for very thin gauge aluminum profiles, including screen door extrusions and frames, aluminum downspout, roll formed shapes, brass, copper tubing, and other fragile non ferrous shapes. This very thin aluminum cutting blade will produce clean, burr free cuts. For use on radial arm saws, table saws, chop saws, and double miter saws. 8 inch diameter M2 steel (60 HRc) 1 16" cutting thickness 5 8" arbor hole Hollow ground for