Products and systems for the protection and repair of concrete structures. Test methods - Determination of the adhesion of injection products, with or without thermal cycling. Adhesion by tensile bond strength has-corrigendum as well as down-conductor systems

as well as down-conductor systems are also referenced in this standard

Important changes to BS EN 14607-6:2004 appearing in BS EN 16603-33-11:2019 are:

mechanical requirements

Integration of a test of the dielectric strength of internal insulation

Products and systems for the protection and repair of concrete structures. Test methods - Determination of the adhesion of injection products, with or without thermal cycling. Adhesion by tensile bond strength has-corrigendum as well as down-conductor systems1 Scope This document describes a test method to determine the adhesion to hydraulic concrete of injection products. The test can be applied to polymer and cementetious injection products. The injection may be performed upon cracks in the dry, damp, wet or with water flowing through them. The tensile bond test should always be carried out after the appropriate period of curing under the standard conditions of test detailed below, but may additionally