Tests on electric and optical fibre cables under fire conditions - Test for vertical flame spread of vertically-mounted bunched wires or cables. Category D Ingestion-build-59651 It usually consists of Nomex

It usually consists of Nomex uniform pants

verification of the safety requirements and/or measures

Calculation of flue gas mass flow rate

Flanged shaft support blocks for series 1 and 3 sleeve type linear ball bearings

Tests on electric and optical fibre cables under fire conditions - Test for vertical flame spread of vertically-mounted bunched wires or cables. Category D Ingestion-build-59651 It usually consists of Nomex1 Scope The series of International standards covered by Parts 3 10, 3 21, 3 22, 3 23, 3 24 and 3 25 of IEC 60332 specifies methods of test for the assessment of vertical flame spread of vertically mounted bunched wires or cables, electrical or optical, under defined conditions. NOTE For the purpose of this standard, the term "electric wire or cable" covers all insulated metallic conductor cables used for the conveyance of energy or signals. The test