Groove Mount Bowden Adapter - 1.75mm Filament steel pla filament Knobs or buttons

Knobs or buttons

No special hardware or nozzles are required for this plant-based composite

Suggested print temperature is 190-230C

EinScan-SP 4 s

Groove Mount Bowden Adapter - 1.75mm Filament steel pla filament Knobs or buttonsThis is a neat little solution for quickly and easily converting a direct extruder that would normally accept a groove mount hotend into a bowden extruder. Simply mounts in like a hotend, but instead accepts our PTFE tubing securely in an embedded bowden coupler. Quite a bit nicer than forcibly screwing a threaded bowden coupler into a printed hole, and allows you to use the existing plethora of excellent direct extruders available in a bowden setup.