Discharge and ventilating pipes and fittings, sand-cast or spun in cast iron - Specification for spigot and socket systems Ingestion-build-89079 BS 6319-1 is the first

BS 6319-1 is the first part of the BS 6319 series that gives a general introduction to the testing of resin compositions and describes a procedure for obtaining samples of resin compositions and preparing test specimens under either declared practical conditions or more closely controlled laboratory conditions

As part of an agreement for the admittance of systems into the open systems environment

Has been fully revised to be more accessible and appropriate for the sector

Note: ISO 22477‑5 does not provide specifications for the size of the proof load and the limiting criteria

Discharge and ventilating pipes and fittings, sand-cast or spun in cast iron - Specification for spigot and socket systems Ingestion-build-89079 BS 6319-1 is the first1 Scope This Part of BS 416 specifies cast grey or ductile iron spigot and socket pipes manufactured by either the sand cast or the spun process, with either Type A or Type B sockets (see Table 1). This Part of BS 416 also specifies sand cast fittings. These pipes and fittings are for use above ground (see 2. 1) in discharge or ventilating pipe systems in buildings. This Part of BS 416 specifies quality of material, critical dimensions and tolerances,