Glass-reinforced thermosetting plastics (GRP) pipes. Determination of the ring creep properties under wet or dry conditions algolia-ignore to open and closed-loop pumping

to open and closed-loop pumping systems typically used at industrial

Retailers and suppliers for cosmetics

NOTE 1 The mechanical requirements for screws that are cited in this International Standard are specified in ISO 6475

Manufacturers of cellulose acetate flakes

Glass-reinforced thermosetting plastics (GRP) pipes. Determination of the ring creep properties under wet or dry conditions algolia-ignore to open and closed-loop pumping1 Scope This document specifies methods for determining the ring creep properties for glass reinforced thermosetting plastics (GRP) pipes. Properties include the creep factor and the long term specific creep stiffness. Testing is performed under either wet (total immersion in water) or dry conditions. Dry creep testing is typically performed for the assessment and control of raw material consistency. Wet creep testing is typically undertaken to