BuildTak - 254 mm x 254 mm (10.0" x 10.0") e3d titan This new formulation is higher

This new formulation is higher performing and lower cost

Although smoke and odor levels are low

Do the same for both extruders

Stainless steel nozzle shall be needed instead of quick-wear bronze nozzle when using CFRPA filament

BuildTak - 254 mm x 254 mm (10.0" x 10.0") e3d titan This new formulation is higherIdeal build surface for FFF 3D printers. Key Features: Works with ABS, PLA, HIPS, PET+, Brick, Wood & Flexible (TPE) filaments; additionally we have had success with getting nylon and t glase (PETT) to adhere when used with a thin layer of washable glue stick on the BuildTak surface Installs much easier than masking tape or films typically used and with fewer chances of air bubbles Protects build plate Heat resistant and durable, can be reused for