Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer included-in-kit The report gives supplementary guidance

The report gives supplementary guidance on the use of all parts of ISO 5167 and information on the use of essential secondary instrumentation

1 to 15 TiO2 0

It’s been updated to align with the UK Government’s mandate for the installation of gas smart meters in all homes by 2020

To ensure the safety of equipment it is recommended that design advice is obtained from a competent person and that appropriate risk-benefit assessment are carried out

Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer included-in-kit The report gives supplementary guidance1 Scope This part of ISO 10649 specifies the dimensions of cutter arbors with parallel key and tenon drive with 7 24 tapers without automatic tool changers.