PrintDry Filament Dryer PRO3 titanium liquid glue for build plate

liquid glue for build plate will leave less residue on the printed model and is easier to clean up

Use the 3D Printer Compatibility Chart below to determine which Bimetallic Heat Break™ is best suited for your application

"What will you make

It is highly recommended to use the PolyBox™ when printing with PolyMide™ CoPA and to store it in the resealable bag

PrintDry Filament Dryer PRO3 titanium liquid glue for build plateEasily adjust the temperature with 6 presets (35C, 45C, 55C, 65C, 75C, and 85C). Built in timer with a maximum time of 48 hours. Note: The temperature readings are directly measured at the tip of the temperature sensor, located about 15 mm away from the hot air vent. The temperature distribution inside the dryer is NOT uniform. The temperature in a place close to the hot air vent is higher and the temperature in a place far away from the hot air vent