Flanges and their joints. Dimensions of gaskets for Class-designated flanges - Spiral wound gaskets for use with steel flanges Ingestion-build-82396 • Electricians

• Electricians

Part 11 specifies methods for the analysis of toy and toy material extracts prepared according to the sampling procedures in EN 71-10

Agreed wording from the IEC technical committee 104 meeting held in Stockholm:2000 on the testing of soft packages

This standard is an introduction to selected methodologies and is intended to provide the necessary information for choosing the most appropriate analysis methods

Flanges and their joints. Dimensions of gaskets for Class-designated flanges - Spiral wound gaskets for use with steel flanges Ingestion-build-82396 • Electricians1 Scope This European Standard specifies the dimensions, design, types, designation, materials and marking of spiral wound gaskets for use with type A flat face or type B raised face flange facings complying with EN 17591 for the following Class designations: Class 150, to Class 1 500 for nominal sizes DN 15 to DN 600, and Class designation 2 500 up to and including DN 300. The centering rings for the spiral wound gaskets according to this standard