Tool holders with rectangular shank for indexable inserts - Style F Ingestion-build-51747 Switchboards

Switchboards

and Annex A

Note: BS 47-1 does not specify requirements for forged or cast fishplates some of its provisions may be applied to such products where appropriate

broadband internet networking cables

Tool holders with rectangular shank for indexable inserts - Style F Ingestion-build-51747 Switchboards1 Scope This part of ISO 5610 specifies tool holders with rectangular shank, style F, i. e. with offset shank and cutting edge angle r = 90 for end cutting. These tool holders are primarily intended for indexable inserts made of hard metal or other cutting materials to be mounted by clamping and to be used for turning operations. NOTE The symbols for the dimensions shown in the tables of this part of ISO 5610 and the corresponding preferred symbols of