Fences - Specification for powder coatings used as a plastics finish to components and mesh Ingestion-build-132972 After-treatment/over-coating of hot dip galvanized

After-treatment/over-coating of hot dip galvanized articles is not covered by this standard

BS EN IEC 61000‑6‑2 applies to electrical and electronic equipment intended to be operated in industrial locations

BS EN 10305-2 provides guidance on classification and designation

often cumbersome

Fences - Specification for powder coatings used as a plastics finish to components and mesh Ingestion-build-132972 After-treatment/over-coating of hot dip galvanized1 Scope This part of BS 1722 species performance requirements and describes methods for laboratory testing of powder coatings and the applied powder coatings used as a nish to fence components and mesh. NOTE Annex A gives some guidance on the care and protection of plastics nishes.