Square Tube Die for Portabender Tube and Pipe Bender (1-1/4" OD, 5" CLR) 105 Heavy Duty

Square Tube Die for Portabender Tube and Pipe Bender (1-1/4" OD, 5" CLR) 105 Heavy DutySpecs Outside Diameter of the Tubing (OD): 1 1 4" (31. 8 mm) Minimum Wall Thickness (Mild Steel): 0. 065" (1. 7 mm) Minimum Wall Thickness (Aluminum): Contact for Details Minimum Wall Thickness (Other): Contact for Details Maximum Wall Thickness: 0. 125" (3. 2 mm) Centerline Radius: 5" (127 mm) Maximum Degree of Bend: 90, after springback Includes Steel Main Die Aluminum Follow Bar Steel U Strap Resources Tube and Pipe Bending Basics What Am I

& Small Swing Arm Pin

Offset Notches: Up to 1/2 the OD of the material

SE provides a graphical layout interface

1-1/2 HP motor comes standard

Most templates allow for center

Plugs into a standard 110V socket

Nominal Pipe Size (Diameter Nominal): NPS 1-1/4 (DN 25)

2" (w) x 1/2" (leg) Channel Stock - Easyway

Minimum Wall Thickness: 0

Hydraulic Pin

Arbor Thread Sizes: 1/2-20 and 5/8-18 (both are on the shaft)

16" x 17" Aluminum Table