Tools for moulding. Sprue pullers Ingestion-build-105964 Stretcher strains

Stretcher strains

Other(generic) generator types such as ground or surface water or direct use of ground heat from boreholes

additional advice on contingency and recovery planning

This British Standard partially supersedes BS 5701:1980 and BS 2564:1955 and all four parts of BS 5701 together supersede BS 5701:1980 and BS 2564:1955

Tools for moulding. Sprue pullers Ingestion-build-105964 Stretcher strains1 Scope This International Standard specifies the main dimensions and tolerances, in millimetres, of sprue pullers, which are used mainly in injection moulds for plastics and rubbers. See the example of application in Figure 1. It also specifies the material, hardness and designation of sprue pullers conforming to this International Standard. Figure 1 Application example of sprue pullers 1 ejector pin (ISO 6751) 2 sprue puller (ISO 16915) 3 locating