Plastics. Resins in the liquid state or as emulsions or dispersions. Determination of apparent viscosity using a single cylinder type rotational viscometer method Ingestion-build-132972 Why should you use BS

Why should you use BS EN 186130 - Type LSA

Electrical engineers/ Electronic engineers

High-pressure decorative laminates sheet consisting of decorative design surface layer(s) and core layers bonded together by an high pressure process

BS EN 14358 also provides the acceptance procedure for the verification of a lot

Plastics. Resins in the liquid state or as emulsions or dispersions. Determination of apparent viscosity using a single cylinder type rotational viscometer method Ingestion-build-132972 Why should you use BS1 Scope This document specifies a method of determining apparent viscosity of resins in a liquid state using a single cylinder type rotational viscometer. The method can be used for viscosity measurements in the range from 0,02 Pa s to 60 000 Pa s. This document is applicable to both Newtonian and non Newtonian liquids and the measured apparent viscosity depends on the velocity gradient to which the liquids are subjected during the measurement.