Tools for pressing. Wear plates for press dies - Type A not-for-sale Compliance with any recommendations in

Compliance with any recommendations in t PD ISO/IEC TR 24714-1 does not of itself confer immunity from legal obligations

Their range of sizes covers nominal outside diameters of PE pipes dn 16 to dn 125 mm and pipe thread sizes 1/2 to 4

BS EN 60360 provides manufacturers with the general conditions for measurements

The determination of these quantities is necessary for

Tools for pressing. Wear plates for press dies - Type A not-for-sale Compliance with any recommendations in1 Scope This part of ISO 9183 specifies the basic dimensions and tolerances in millimetres of wear for press dies, type A, intended for use mainly in large press dies. It also specifies the size and positions of the clearance holes for attachment. It gives material indications, and specifies the designation of wear plates for press dies, type A, which meet the requirements of this part of ISO 9183. Two thicknesses of this type of wear plate are