1-1/4" PVC Push Cap Compression Points As it advances It will

As it advances It will chase the hole and push back out of the way any roots

2” diameter holes

This pull connector will make a secure and strong connection to any 2" rolled Polyethylene conduit for fiber optic - Poly pipe for water lines or -Polyethylene pipe for gas lines  Etc

Then as the tool is driven through the ground the 3" drain cap actually pushes the pipe into the hole simultaneously as the Bullet Mole pierces the ground and advances under the pavement

1-1/4" PVC Push Cap Compression Points As it advances It willThe push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed. The push point is connected to the front or leading end of the pipe and the push cap is inserted into the bell housing on the opposite end of the same pipe, or If there is no bell housing then a coupling must be glued onto the pipe and the part inserted into the coupling. Once in place, the push cap may be struck with a