E3D High Precision Heater Cartridge 3D Printer Filament In less than 15 seconds
$22.00
Description
In less than 15 seconds MODIFI3D will reach around 300ºC (572ºF) and is ready for use
good results were achieved using standard PLA parameters with standard build surface preparation (blue tape
PLATEBOND™ is a UV cured build-plate adhesion promoter
ePC is flame retardant has been tested and analyzed by the manufacturer and was found to meet the requirements of UL94-V2
E3D High Precision Heater Cartridge 3D Printer Filament In less than 15 seconds12v or 24v 30w or 40w Ceramic Heater Cartridge A powerful heater for your HotEnd, with improved reliability and highly precise temperature output. A high tolerance canister boosts thermal efficiency, while a built in Molex connector makes removing your HotEnd from your 3D printer easier than ever. Key Features Highly precise temperature output Improved Reliability Attached to a connector for quick release High tolerance canister for maximum thermal
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
