Pliers and nippers for electronics. Test methods Ingestion-build-180956

Pliers and nippers for electronics. Test methods Ingestion-build-1809561 Scope This International Standard specifies the methods of test for checking the correct functioning of pliers and nippers for electronics. The test parameters have been specified on the basis of the functional uses of the tools.

Note 1: The present BS EN 13203-5 does not apply for gas boilers with recovery systems using combustion products as heat sources for the electric heat pump

The test conditions described in BS EN 61514 (for example range of ambient temperatures and power supply) relate to conditions that commonly arise in use

and in locations with electromagnetic disturbances

specifies a system of single sampling schemes for lot-by-lot inspection by attributes

BS 6211 helps you to ensure that operators are able to work efficiently and avoid injuries related to improper placement of controls

It gives you the much-needed information about chemical composition and alloy designation

kept up to date

used for the transfer of vapour between the tank compartment and the pipework connecting to the vapour collection adaptor

this international standard allows for either or both to be used

BS EN 4199-002 on bonding straps for aircraft industry is useful for:

Test for materials in the cured form

BS EN 13832‑1 specifies the test methods to determine the protection of footwear from chemical splashing