End mills and slot drills - Dimensions and designation of milling cutters with Morse taper shanks Ingestion-build-53008 For aspects of quality specific

For aspects of quality specific to the finger image modality

The Health and Safety Executive (HSE) commends the use of this British Standard to those who have duties under the Health and Safety at Work Act 1974

Product development teams/innovation team

BS EN IEC 60793‑1‑49 applies only to multimode

End mills and slot drills - Dimensions and designation of milling cutters with Morse taper shanks Ingestion-build-53008 For aspects of quality specific1 Scope This part of ISO 1641 specifies the general dimensions and designation of the following milling cutters with Morse taper and having a tapped hole: end mills, flat ended or ball nosed standard series and long series; slot drills short series and standard series. Morse taper shanks are in accordance with ISO 296 and ISO 5413. It is not applicable to the end mills and slot drills with cylindrical shank, which are dealt with in ISO 1641 1; it is