1-1/4" PVC Push Point Compression Points The actual diameter of this

The actual diameter of this part is 2" in

The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed

There are 2 half pipe indicator lines cut into the point

As the shafts are extracted the tape or line is pulled into the hole which can then be attached to the microduct and installed

1-1/4" PVC Push Point Compression Points The actual diameter of thisThis part is used to insert a 1 1 4" PVC Sch 40 pipe into the ground after the initial hole is opened with the compression point. The point is screwed into the PVC pipe and cuts threads on the inside of the pipe much like a tap. The Push Point will have the same as the outside diameter of the pipe itself. After the Push Point is attached the pipe then this assembly is shoved into the hole made by the compression point. As it proceeds, roots or