Data Rig Compression Points 1-1/8" hex bit connected to

1-1/8" hex bit connected to the jackhammer

Pelican Case

As the shafts are extracted the tape or line is pulled into the hole which can then be attached to the microduct and installed

This unique design combination allows for the female threaded end of the connector to be easily manuvered in order to quickly "FIND" the male thread of the shaft and be connected to it

Data Rig Compression Points 1-1/8" hex bit connected toThis rig is used to punch holes and install micro duct from the edge of the sidewalk to the road with very minimal disturbance to the lawn next to the sidewalk. It requires a very shallow and short entrance trench approx 6 Inches deep and 24 to 30 inches long depending on the angle. The rig itself attaches to the sidewalk and does not require that stakes or anchoring devices be driven into the property owners soil next to the sidewalk The trajectory