Limits and fits. Guidance for system of cone (taper) fits and tolerances for cones from C = 1:3 to 1:500, lengths from 6 mm to 630 mm and diameters up to 500 mm Ingestion-build-156411 This standard does not cover

This standard does not cover cold rolled flat products for which separate standards already exist

Following up - how effective were you

The purpose of this standard is to establish definitions

Diameter steps

Limits and fits. Guidance for system of cone (taper) fits and tolerances for cones from C = 1:3 to 1:500, lengths from 6 mm to 630 mm and diameters up to 500 mm Ingestion-build-156411 This standard does not coverBS 4500: 2009 Limits and fits. Guidance for system of cone (taper) fits and tolerances for cones from C = 1: 3 to 1: 500, lengths from 6 mm to 630 mm and diameters up to 500 mm BS 4500 gives guidance on a system of cone fits and tolerances for cones from C = 1: 3 to 1: 500 and lengths from 6 mm to 630 mm. The appropriate tolerances of BS 4500 can also be used for prismatic workpieces, for example wedges. BS 4500 applies to cones which are dimensioned