Servo Lead/Terminal Crimping Tool Spare Tire Mount 5830: Slash 2WD Low-CG Chassis

5830: Slash 2WD Low-CG Chassis Conversion Kit with installation hardware

This slipper set is supplied pre-built and ready to install in your vehicle

and its sleek lines are enhanced by an internal antenna that is impervious to damage

The enhanced SkyRC SCWS2000 can help drivers easily measure and identify the corner weight distribution

Servo Lead/Terminal Crimping Tool Spare Tire Mount 5830: Slash 2WD Low-CG ChassisProTek RC Servo Lead & Terminal Crimping Tool PTK 1999 The ProTek RC Servo Lead & Terminal Crimping Tool is the tool you need to make custom length signal wires for your ESCs, receiver batteries and servos. This tool safely secures the connector pins on wire sizes between 14 and 28awg, without damaging the pin or the wire. Simply strip a short length of the shielding off the wires, install the connector pin into the tool, insert the wire into the pin,