Slice Engineering Filament Drying Desiccant pro series

Slice Engineering Filament Drying Desiccant pro seriesActivated alumina desiccant is 10x more powerful than comparable silica gel, and is non toxic! Creates enough of a relative humidity (Rh) gradient to absorb both surface moisture and water particles captured inside the filament. Stainless steel canister is perfectly sized to fit in the center of your filament spool. Desiccant is infinitely rechargeable in the stainless steel container. Humidity indicator card included. To use simply remove the outer

automatic scanning for better accuracy

Volume Flow Rate [mm³/s] 2-3

4 collection on a board to solve the Ramps1

Flashforge Activated Carbon Air Filter compatible with Guider 2S / Guider 2S High Temp

then let dry

Replace the motor drive

75mm Filaments only

The battery last about 2 months if only opening and closing once a day

It's done manually but it works

The printed model has high dimensional stability

The 4 Phases of Bondtech DDX for Creality

This is where the Nozzle X comes in