Mopeds. Measurement methods for location of centre of gravity Ingestion-build-202139 These methods are primarily intended

These methods are primarily intended for testing the sheet specified in EN 438-3

for the measurement of gauge pressure

ISO 4796-2 specifies a series of bottles with a conical

hold to run devices and as special control devices

Mopeds. Measurement methods for location of centre of gravity Ingestion-build-202139 These methods are primarily intended1 Scope This International Standard specifies a measuring method for determining the location of the centre of gravity of the moped and of the moped rider combination. It applies to two wheeled mopeds. Other measuring methods can be used if it is demonstrated that the results are equivalent. The measuring results obtained by the method given in this International Standard alone (see Annex A) cannot be used for an evaluation of the vehicle stability